[GTER] Problema na ativação Frame-Relay Telefonica

[Valter Pereira da Costa]

Meu caro,

Voce tem certeza sobre o DLCI ser 111? 

Em caso afirmativo, o proximo ponto a verificar em um roteador Cisco seria o encapsulamento...para routeadores Cisco a configuracao seria:

encapsulation frame-relay IETF

Voce tambem pode verificar os logs do roteador:

show logging

Por ultimo mas nao menos importante...o ping usa ICMP e nao eh incomum adminstradores bloquearem as respostas de icmp. Se voce tiver outro endereco IP para usar, pode ser interessante.

Abracos.
Valter
 

-----Original Message-----
From: gter-bounces at eng.registro.br [mailto:gter-bounces at eng.registro.br] On Behalf Of Ilicilho Netto
Sent: 2009-03-02 16:33
To: Grupo de Trabalho de Engenharia e Operacao de Redes
Subject: Re: [GTER]Problema na ativação Frame-Relay Telefonica

Caros

Novamente a telefonica me deixou na mão com um frame-relay Problema igual o que passei anteriormente.
Configuro a interface, fica UP, porem, nao consigo dar ping no next-hop(router da telefonica.
Segue abaixo o show-run e o show interface para quem puder me dar uma ajuda

interface Serial0/1/0
 description -------------- REDE TELEFONICA -----------  no ip address  encapsulation frame-relay  frame-relay lmi-type q933a

interface Serial0/1/0.241 point-to-point  ip address 201.xx.xx.10 255.255.255.252  frame-relay interface-dlci 111
  load-interval 30

Serial0/1/0 is up, line protocol is up
  Hardware is GT96K Serial
  Description: -------------- REDE TELEFONICA -----------
  MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation FRAME-RELAY, loopback not set
  Keepalive set (10 sec)
  CRC checking enabled
  LMI enq sent  643, LMI stat recvd 33, LMI upd recvd 0, DTE LMI up
  LMI enq recvd 0, LMI stat sent  0, LMI upd sent  0
  LMI DLCI 0  LMI type is CCITT  frame relay DTE  segmentation inactive
  FR SVC disabled, LAPF state down
  Broadcast queue 0/64, broadcasts sent/dropped 306/0, interface broadcasts 0
  Last input 00:00:08, output 00:00:08, output hang never
  Last clearing of "show interface" counters 05:10:18
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations  0/1/256 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 1158 kilobits/sec
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     495 packets input, 64621 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throt  0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     343 packets output, 12245 bytes, 0 underruns
     0 output errors, 0 collisions, 6 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

Serial0/1/0.241 is up, line protocol is up
  Hardware is GT96K Serial
  Internet address is 201.xx.xx.10/30
  MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation FRAME-RELAY
  CRC checking enabled
  Last clearing of "show interface" counters never
--
gter list    https://eng.registro.br/mailman/listinfo/gter