[GTER] Autenticação Roteador Apple com BRAS Cisco

[Wagner Bento]

Boa tarde pessoal, tudo certo?

Me deparei com uma situação estranha, onde um Apple AirPort Extreme 802.11n
(4a. geração) não autentica no meu BRAS ASR 1002 X Cisco.

Ao que me parece, logo após tentar autenticar, o próprio roteador pede pra
encerrar.

Alguém pode me ajudar a entender o que está acontecendo?


Vi2.1071 PPP: Phase is AUTHENTICATING, Authenticated User
Vi2.1071 PAP: O AUTH-ACK id 98 len 5
Vi2.1071 PPP: Phase is UP
Vi2.1071 IPCP: Protocol configured, start CP. state[Initial]
Vi2.1071 IPCP: Event[OPEN] State[Initial to Starting]
Vi2.1071 IPCP: O CONFREQ [Starting] id 1 len 10
Vi2.1071 IPCP:    Address 0.0.0.0 (0x030600000000)
Vi2.1071 IPCP: Event[UP] State[Starting to REQsent]
Vi2.1071 IPV6CP: Protocol configured, start CP. state[Initial]
Vi2.1071 IPV6CP: Event[OPEN] State[Initial to Starting]
Vi2.1071 IPV6CP: O CONFREQ [Starting] id 1 len 14
Vi2.1071 IPV6CP:    Interface-Id 0278:88FF:FE21:5C00
(0x010A027888FFFE215C00)
 Vi2.1071 IPV6CP: Event[UP] State[Starting to REQsent]
Vi2.1071 LCP: I TERMREQ [Open] id 229 len 4
 Vi2.1071 PPP DISC: Received LCP TERMREQ from peer
Vi2.1071 PPP: Sending Acct Event[Down] id[77974D]
 PPP: NET STOP send to AAA.
Vi2.1071 PPP: Phase is TERMINATING
Vi2.1071 IPCP: Event[DOWN] State[REQsent to Starting]
Vi2.1071 IPCP: Event[CLOSE] State[Starting to Initial]
Vi2.1071 IPV6CP: Event[DOWN] State[REQsent to Starting]
Vi2.1071 IPV6CP: Event[CLOSE] State[Starting to Initial]
Vi2.1071 LCP: O TERMACK [Open] id 229 len 4
Vi2.1071 LCP: Event[Receive TermReq] State[Open to Stopping]


Abaixo as configurações da minha template:

interface Virtual-Template1
 description BRAS-VirtualTemplate
 mtu 1492
 bandwidth 10000000
 ip unnumbered Loopback0
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 ip nat inside
 ip tcp adjust-mss 1452
 no logging event link-status
 peer default ip address pool CGNAT
 peer default ipv6 pool WAN-Clientes
 ipv6 unnumbered Loopback0
 ipv6 enable
 ipv6 nd managed-config-flag
 ipv6 nd other-config-flag
 ipv6 nd router-preference High
 no ipv6 nd ra suppress
 ipv6 dhcp server LAN-Clientes
 no snmp trap link-status
 keepalive 30 3
 ppp max-bad-auth 8
 ppp disconnect-cause keepalive lost-carrier
 ppp authentication pap chap ms-chap ms-chap-v2 RADIUS-PPPOE
 ppp authorization RADIUS-PPPOE
 ppp accounting RADIUS-PPPOE
 ppp ipcp dns x.x.x.x
 ppp ipcp mask 255.255.255.255
 ppp ipcp ignore-map
 ppp ipcp address required
 ppp ipcp address unique
 ppp link reorders
 ppp timeout authentication 30
 ip virtual-reassembly


Atenciosamente.